More than sensors+automation

How can the error message 'PROFIBUS-DP ERROR' be suppressed if the PROFIBUS interface is not (yet) used?

If the IMAGO 500 is equipped with a PROFIBUS interface that is not yet used, then the error message "PROFIBUS-DP ERROR" will appear on the display.
This error message can be suppressed by entering the PROFIBUS device address "0" directly from the keys of the IMAGO 500.
From setup program version 162.03.xx 3.00(J) upwards, you can also use a PC to set the PROFIBUS device address to "0".