More than sensors+automation
Search

Fast, Cost-Effective, User-Friendly

The new JUMO PINOS L01 flow sensor

PI 1885

Fast, Cost-Effective, User-Friendly

Flow sensors are required in a range of sectors and applications. With the PINOS L01, JUMO presents an electronic variant intended for use in water and watery mediums. It can be used, for example, to check cooling circuits, compressors, pumps, and heat exchangers. However, the new device can also be used to monitor leaks, to protect pumps against dry running, and in lubricant circuits.


The JUMO PINOS L01 is characterized by its simple installation that does not depend on direction, and easy operation. Configuration occurs over an USB interface with a user-friendly setup program that is used in many other JUMO devices. Customized setup ex works is also possible.


A measured value is issued via an analog output (0(4) to 20 mA). The PINOS L01 can be used for a nominal pressure of up to 25 bar and in a permissible flow range of 10 to 150 cm/s.


The process connection is established using suitable stainless steel fittings. Other materials may be used as well. The PINOS L01 is also available with a switching output for which the switching point can be set on-site. A so-called window opening/closing function is included so that the switching points can be determined for a specific measuring range.


With its robust design that complies with protection type IP 65/67, the flow sensor can also be used in harsh environmental conditions. Reliable operation is guaranteed in ambient temperatures from -25 to +70 °C. Measurement medium temperature can range between -25 and +80 °C.


The new flow sensor works according to the calorimetric measurement principle. Here, the measurement is taken using temperature sensors that do not have moving parts. The sensor is submerged in the flowing medium which washes around it. A heating element and a temperature sensor make up the sensor – on the one hand, the heating element is continuously supplied with a small amount of electrical energy while at the same time this temperature increase in the sensor is discharged through the flowing liquid. The temperature conditions that arise are measured by the temperature sensor. In simple terms, the faster the liquid flows, the greater the heating element is cooled. Consequently, the flow speed of the liquid can be determined using a simple temperature measurement.

Downloads

Contact

Editorial information

Michael Brosig
Phone: +49 661 6003-238
Email: Vorname Punkt Nachname at jumo Punkt net

Technical Information

Stefan Büchner
Phone: +49 661 6003-2475
Email: Vorname Punkt Nachname at jumo Punkt net